AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Repetition Times: thick materials may need to be repeatedly cut.Equipped with 1.6W 445nm high power solid-state lasers, and cooperating with its software mLaser, LaserBot can easily engrave and cut many things for you, and help you to make surprises in daily life.For instance, making Christmas cardsbirthday cards for your families, or engrave your honeymoon photos on the wood for decoration, etc.
WARNING: As laser energy gains higher density, make sure corresponding protection measures are taken while using. No direct eye-contact with the laser light path; DO NOT irradiate others by the laser; Keep away from children and other people who are not familiar with laser usage; When the laser is used, take eye protection measure When certain materials are cut by the laser, it is possible for them to produce toxic smoke, take ventilation measures. Engrave Name On Volk Lenses Serial Port NumberThe serial port number of the computer connected to the MegaPi is COM5 in this Manual). The serial port number of the computer connected to the MegaPi is COM5 in this Manual), then click Connect. Upon a successful connection, a prompt in the following figure is displayed. LaserBot will begin to carry out laser engraving according to the default procedures.(the picture shown below). The simple mode only allows LaserBot to engrave with default parameters. The interface of the simple mode is shown in the following figure. In the case that axes do not move towards the direction of limit switches, the power should be turned off immediately. In the case of a failure in reset, please check whether the wiring is correct again. If the material is beyond this area, the material should be moved or the initial point for engraving should be adjusted. Click Engrave on the third line on the right side of the interface (the figure on the left) and switch to the following interface (the following figure on the right). For example, when engraving name, the entered text will be displayed in black. In this mode, the engraved images will show changes in color. The application scenarios of these two modes can be compared through the following figures. It is strongly recommended to engrave black-and-white (colorless) images in the black and white mode; otherwise some image details will be lost. There is an Pic Type option in this mode, under which there are two another options: gray and White Black. As the photo to be engraved is a full-color photo, the gray mode should be selected. In addition, the user should know that images in SVG and DXF are vector graphics and cant be engraved in the gray mode. The parameters to be set in the process of using mLaser are introduced in this chapter to allow you to use it more flexibly. As we have learnt the difference between these two modes, their parameters are introduced in details in this chapter.
0 Comments
Read More
Leave a Reply. |